|
|
Tornadoes in Oklahoma Causing Service Delays
Damage is causing some unavoidable service delays in portions of the affected area. Please
check FedEx.com and
UPS.com for
further detailed information on possible delays.
|
|
|
|
Loading...
![]() 
|
WiFi Bridge Kit – Connect Point to Point, up to 3 miles
|
|
|
|
In Stock: Usually Ships Within 1 Business Day.
|
|
|
|
|
|
|
|
$249.95
|
|
Item #
WBK
|
| Securely beam your network and Internet connection to a second location up to 3 miles away. The WiFi Bridge Kit works like an extremely long ethernet cable that can connect to a device like a computer or router. ...more |
|
|
|
|
60-Day Satisfaction Guarantee
|
Lifetime Tech Support
|
|
|
|
|
|
|
|
| Comes Configured and Wired - Easy Setup, High Value The WiFi Bridge Kit is the best way to connect two locations on the same router. This kit is very simple to set up. It comes preconfigured and wired by C. Crane so there are no settings to adjust or software to install. Just attach the antennas (sold separately) to each half of the bridge, at each location, and plug them in. Use larger antennas like the Point-To-Point WiFi Antenna for long distances, or smaller antennas for shorter distances. Good line of sight without obstructions must be achieved between both antennas for best reception. LED lights on each bridging device make it easy to align your antennas with each other. Will it work for me? - Requires line of sight between two points (no obstructions, not even a tree)
- Must be within three miles
- Antenna must be mounted outside at approximately roof height at each location
- You must have a router and Internet service at one location
You will need to connect the first half of the Wifi Bridge, using the supplied Ethernet cable, to an empty LAN port on your router. The Wireless Bridge then beams the encrypted Internet signal to your second location wirelessly. The second half of the kit terminates with an Ethernet cable that provides Internet and network connectivity to one computer or other device like a WiFi router. You will need power at the second location to power the Bridge. The signal between the two points of the WiFi Bridge Kit cannot be intercepted by a computer or other device and is very secure. The cost of the WiFi Bridge Kit is a fraction of the more expensive proprietary systems. It provides up to 24Mbps of throughput which is faster than most Internet Service Provider download speeds. File transfer between two computers is limited to this same speed also. Up to 150 feet of regular low cost Cat-5 or Cat-6 Ethernet cable (not included) can be used to mount the antenna even further away on top of a tree or tower. Technical Info This kit is designed to be plugged into a router that is configured using Dynamic Host Configuration Protocol (DHCP) which is the standard factory configuration of most routers. An Internet Connection is also required. |
- Host Bridge
- Client Bridge
- 50-foot Ethernet Cable (2)
- 5-foot Ethernet Cable (2)
- Power Injector (2)
- Pack of Coax-Seal (2)
- Silicone Packet (2)
|  | Note: Antennas are not included with this kit. They are sold separately |
|
|
Yes, you can. You hop WiFi signals from the ‘client’ house to another ‘client’ house. To do this you will need an additional WiFi Bridge Kit and an additional router. You would connect the second bridge kit to the second router.
|
| Processor: | Atheros MIPS 4KC, 180MHz | | Memory Information: | 16MB SDRAM, 4MB Flash | | Networking Interface: | 1 X 10/100 BASE-TX (Cat. 5-6, RJ-45) Ethernet Interface | | WiFi Mode: | 802.11b/g mixed | | WiFi Power: | 20dbm max | | Security: | 504 bit WPA2 Encryption with Half Channel Technology | | Approvals: | FCC Part 15.247, IC RS210 | | RoHS Compliance: | YES | | Antenna Connector: | N-Male | | Power Supply: | Input 100~240 50-60Hz --- Output 15V DC (800ma) | | Power Method: | Passive Power over Ethernet (pairs 4,5+; 7,8 return) | | Operating Temperature: | -4 degrees Fahrenheit to +158 degrees Fahrenheit | | Bridge Device Weight: | 6.5 ounces | | Bridge Kit Weight: | 7Lbs | | Ethernet Cable #1: | 50 FT, White, Category 6 Enhanced 550MHz, ANSI/TIA/EIA 568B.2, UTP Unshielded Twisted Pair, PVC Jacket, 24 AWG, Gold Plated Connectors | | Ethernet Cable #2: | 5 FT, Blue, Category 5 Enhanced 350MHZ, TIA/EIA 568B.2, UTP Unshielded Twisted Pair, PVC Jacket, 24 AWG, Gold Plated Connectors |
|
|
|
|
|
Copyright © 2013 by
C. Crane Company, Inc.
1001 Main Street
Fortuna, CA 95540
(800) 522-8863
|
|
|
|